The Landoll Model 2110 Coulter Chisel is a quality product designed to give years of trouble free performance. By following each section of this manual, your system will perform as designed for you and your operation. Landoll Corporation warrants each new serial numbered Whole Good Tillage product, when properly assembled, adjusted, ser- viced, and normally operated, to be free from defects in materials and workmanship for a period of three (3) years, unless other- wise noted, from the date of delivery. Date of delivery shall be the date the Dealer places the product in the possession of the original retail purchaser, and must be confirmed by the Dealer submitting a properly completed Landoll Corporation Warranty Registration Form to the Landoll Corporation Warranty Department. Warranty starts the day the product is rented or leased. This limited warranty shall be transferable until the expiration date.
Landoll Corporation shall repair, or at its option, replace any part(s) of the product determined, by Landoll Corporation, to be de- fective. Landoll Corporation may request the return of part(s), freight prepaid via a carrier approved by the Landoll Warranty Staff, to Landoll Corporation for further evaluation. If the part is determined to be defective, Landoll Corporation will refund the freight charges incurred in returning the defective part(s), and will prepay replacement part(s) freight charges.
This limited warranty requires pre-authorization by the Landoll Corporation Warranty Staff of any warranty related utilization of components or labor, and is subject to specific exclusions and does not apply to any product which has been: 1) subjected to or operated in a manner which, at any time, have exceeded the product design limits: 2) repaired or altered outside our factory in any way so as, in the judgment of Landoll Corporation, to affect its stability or reliability: 3) subject to misuse, negligence, acci- dent, or has been operated in a manner expressly prohibited in the instructions; or not operated in accordance with practices ap- proved by Landoll Corporation. Operating the product in soils containing rocks, stumps or obstructions may void the warranty in its entirety. Excessive acres, consistent
The sole obligation of Landoll Corporation under this warranty shall be limited to repairing or replacing, at its option, part(s) which shall be identified to Landoll Corporation by way of a pre-authorized Landoll Corporation e-mail Warranty Claim Form Warranty, expressed or implied, will be denied on any product not properly registered with the Landoll Corporation Warranty Department within ten (10) days of the first retail sale. As stated above, Landoll Corporation Warranty Staff will identify components listed on a Warranty Claim required to be returned for further analysis. All parts returned to Landoll Corporation must be shipped with a Return Materials Authorization (RMA) provided by the Landoll Corporation Warranty Staff. Defective components must returned by the purchaser to Landoll Corporation with transportation and freight charges prepaid within fifteen (15) days after receipt of the RMA. The examination.
All parts and labor warranty MUST be pre-authorized by Landoll Corporation Warranty Staff. Failure to do so may result in no warranty payment of any kind. Labor will be reimbursed in accordance with published shop rates pre-approved by the Landoll Corporation Warranty Staff. Time authorized for specific work will be limited, where appropriate, to the hours listed in the Landoll Corporation authorized Labor Rate Guide.
Landoll 2110 COULTER CHISEL REAR JACK INSTALLATION
A rear jack assembly is available for use on the rear of the Coulter Chisel. This is extremely helpful if an attachment has been added to the rear of the machine for stability. Attach rear jack mount and rear jack mount plate weldment to the rear frame of the Coulter Chisel using 5/8-11 x 6 hex head cap screws and hex lock nuts (See Figure 3-14).