Claas Dominator-58-48-38 Service Manual

These economic OMI-NATOREN are combine harvesters with the typical features that identify a CLAAS. Specially for agricultural businesses with modern full mechanization, unite all the advantages that are required for the upper performance class which have meanwhile become a matter of course in the CLAAS MShdrescher range. their operational safety, their efficiency, their economy in maintenance and for CLAAS well-known high resale value results from the particular these models.

Claas Dominator-58-48-38 Service Manual
The CLAAS storage crop cutterbar is hard to beat. You can harvest without cutting losses. Specially built for heavy and stored grain, it takes on the ground lying weedy crop clean. The DOMINATOR 58 comes with a 3 m cutting unit equipped. DOMINATOR 48 and 38 come standard with 2.70m wide headers. Since you do not need to remove this cutterbar for driving on the road, you can Place of use immediately with the harvest start.

The two three-part crop dividers are part of the basic equipment. They are flexibly suspended and can be adjusted as required. They push themselves into the grain like a wedge and separate even the heaviest and most overgrown stored fruit perfectly and gently.

Spring steel tail lifters are also supplied as standard. she lift flat-lying stalks out of the undergrowth and adapt elastically to the unevenness of the ground. The distance between the cutter bar and the intake auger is unusually large: 620 mm. Even if the grain towards the cutterbar stored, it is basically before cut indent. The intake auger only grasps the stalks when they are cut off. Hence also do not take roots with them earth in the machine.

The reel with controlled spring tines ensures an uninterrupted, even flow of the crop to the intake auger. It is hydraulic in height and in the horizontal mechanically, on request also hydraulic, adjustable. The reel speed is from the driver's cab Control drive changed. The fingers of the auger carry what has been pushed towards the middle by the snail coils Harvest to the Schrachfbrderer. The position of the fingers can be changed to suit both long and short crops.

The cutting height setting is Made above hydraulic cylinder. Strong coil springs relieve the cutterbar up to about 50 kg support weight. That's right it is upper width, adjustable Skids automatically adapt to uneven ground. The Schrdgfdrderer - three (DOMINATOR 58 and 48) or two (DOMINATOR 38) chains with bolted bars - transported the crop continuously to the threshing organs.