CARRIER SPECIFICATIONS
ENGINE
Model HINO W04D-T
Type 4-cycle, 4-cylinder, direct-injection, water-cooleddiesel engine (with turbo charger)
Piston displacement 4,009cc
Max. output 150PS at 3,000rpm
Max. torque 38.0kg.m at 1,800rpm
PRECAUTIONS TO BE TAKEN WHEN THE OUTRIGGERS ARE EXTENDED:
- The values in parentheses are for TR-100M.
- The total rated loads shown are for the case where the crane is set horizontally on firm level ground. They include the weights of the slings and hooks. The values above the bold lines are based on the crane strength while those below are based on the crane stability.
- Since the total rated loads are based on the actual working radii including the deflection of the boom, operations should be performed in accordance with the working radii.
- The total rated load for the single top shall be the value obtained by subtracting the weight of the main hook from the total rated load of the boom and must not exceed 1.4t.
- As a rule, free-fall operation should be performed only when lowering the hook alone. If a hoisted load must be lowered by free-fall operation, the load must be kept below 1/5th of the total rated load and sudden braking operations must be avoided.
- The chart below shows the standard number of part lines for each boom length. The load per line should not exceed 1.25t for the main winch and 1.4t for the auxiliary winch.
- The hoisting performance for the "Over sides" range will differ according to the extended width of the outriggers. Operations should be performed in accordance with the performance corresponding to the extended width. Also, although the hoisting performances for the "Over front" and "Over rear" ranges are equivalent to those of the "outriggers fully extended" condition, the front and rear ranges (angle a) will differ according to the width to which the outriggers are extended in the left and right directions.
PRECAUTIONS TO BE TAKEN WHEN THE OUTRIGGERS ARE NOT MOUNTED:
- The total rated loads shown are for the case where the tire air pressure on firm level ground is as specified (8.00kgf/cm2). They include the weights of the slings and hooks. The total rated loads for using the spring lock are for the case where the spring-lock cylinder is extended as much as possible in addition to the above, which are based on the tire strength. The foundation, working conditions, etc. should be taken into consideration for actual work.
- Since the total rated loads are based on the actual working radii including the deflection of the boom and the tires, operations should be performed in accordance with the working radii.
- If the spring lock is not available or not used, no load can be hoisted in the over-side area. "Over front" crane operations should be performed only when the AML "over-front area indicator lamp" is lit. The boom must be kept inside a 2° area over front of the carrier when performing "Over front" crane operations without the outriggers.
- The total rated load for the single top shall be the value obtained by subtracting the weight of the main hook from the total rated load of the boom and must not exceed 1.4t.
- Free-fall operations should not be performed without outriggers. Booms over 8.8m (12.4m when the spring lock is used) in length should not be used without outriggers.
- The "Drive, Speed Selection" switch should be set to "4-wheelă» Lo" for creeping while hoisting a load.
- When creeping while hoisting a load, the swing brake should be applied, the load should be kept as close to the ground as possible but not touching the ground and the speed should be kept at 1.6km/h or less. In particular, any abrupt steering, starting or braking must be avoided.
- Crane operations should not be performed when creeping while hoisting a load.