Mazda Tribute 2006 Dome lamps and map lamps
The front dome lamp is located overhead between the driver and passenger seats. The dome lamp is preset to illuminate when a door is opened and will remain on for 25 seconds after the door is closed. To manually turn on the dome lamp, rotate the panel dimmer control, located on the instrument panel, to the full upright position past the detent.
To turn off the domelamp, rotate the panel dimmer control to the full down position past the detent. Note: When manually in the off position, the dome lamp will not illuminate when the door(s) are opened. The map lamp controls (without moon roof) are located on the dome lamp. Press the button on either side of each map lamp to illuminate the lamps. Press the button again to turn off the lamps.
For models equipped with a moon roof, the map lamps are located on the moon roof control panel. Press the button on either side of each map lamp to illuminate the lamps. Press the button again to turn off the lamps. The map lamps will illuminate whenever a door is opened. After the door is shut, the lamps will remain illuminated for 25 seconds. mazda cx5,cx5 mazda,mazda 3,mazda miata,miata,mazda cx30,mazda dealer,mazda dealerships,mazda cx 9,mazda rx7,mazda cx 5 2020,,2020 mazda cx 5,2020 mazda cx-5,cx 5,mazda3,mazda3 sedan,mazda 3 sedan,mazda dealer usa,mazda dealerships location,mazda houston,mazda cx 9 dimensions,mazda cx 50,mazdacx50,mazdacx 5 redesign,2022 mazda cx 5,dealer mazda, mazda cx 9 car and driver,car and driver mazda cx 9, mazda 2022.
Mazda Tribute 2006 Lamp assembly condensation
Exterior lamps are vented to accommodate normal changes in pressure. Condensation can be a natural by-product of this design. When moist air enters the lamp assembly through the vents, there is a possibility that condensation can occur when the temperature is cold. When normal condensation occurs, a thin film of mist can form on the interior of the lens. The thin mist eventually clears and exits through the vents during normal operation. Clearing time may take as long as 48 hours under dry weather conditions.
Examples of acceptable condensation are:
- Presence of thin mist (no streaks, drip marks or droplets)
- Fine mist covers less than 50% of the lens Examples of unacceptable moisture (usually caused by a lamp water leak) are:
- Water puddle inside the lamp
- Large water droplets, drip marks or streaks present on the interior of the lens
Take your vehicle to dealer for service if any of the above conditions of unacceptable moisture are present. Using the right bulbs Replacement bulbs are specified in the chart below. Headlamp bulbs must be marked with an authorized “D.O.T.” for North America to ensure lamp performance, light brightness and pattern and safe visibility. Note: The correct bulbs will not damage the lamp assembly or void the lamp assembly warranty and will provide quality bulb burn time.