This vehicle has been designed and built to withstand the normal stresses and strains of road use. This vehicle is not suitable for use on race tracks or offroad. All work marked with this symbol requires specialist knowledge and technical understanding. In the interests of your own safety, have these jobs performed by an authorized Husqvarna Motorcycles workshop. There, your motorcycle will be optimally cared for by specially trained experts using the specialist tools required.
The vehicle must only be used as intended. Dangers can arise for people, property and the environment through use not as intended. Any use of the vehicle beyond the intended and defined use constitutes misuse. Misuse also includes the use of operating and auxiliary fluids which do not meet the required specification for the respective use.
Tampering warning
Tampering with the noise control system is prohibited. Federal law prohibits the following acts or the causing there of:
- The removal or rendering inoperative by any person other than for purposes of maintenance, repair, or replacement, of any device or element of design incorporated into any new vehicle for the purpose of noise control prior to its sale or delivery to the ultimate purchaser or while it is in use, or
- the use of the vehicle after such device or element of design has been removed or rendered inoperative by any person.
Among those acts presumed to constitute tampering are the acts listed below:
- Removal or puncturing of the main silencer, baffles, header pipes or any other components which conduct exhaust gases.
- Removal or puncturing of parts of the intake system.
- Lack of proper maintenance.
- Replacing moving part of the vehicle, or parts of the exhaust or intake system, with parts other than those specified by the manufacturer.
Have malfunctions that impair safety immediately eliminated by an authorized Husqvarna Motorcycles workshop. Adhere to the information and warning labels on the vehicle.
Work rules
Special tools are necessary for certain tasks. The tools are not a component of the vehicle, but can be ordered using the number in parentheses. Example: bearing puller (15112017000) During assembly, use new parts to replace parts which cannot be reused (e.g. self-locking screws and nuts, seals, sealing rings, O-rings, pins, and lock washers). In the case of certain screws, a thread locker (e.g. Loctite®) is required. Apply according to the manufacturer's instructions. After disassembly, clean the parts that are to be reused and check them for damage and wear. Change damaged or worn parts. After completing a repair or service work, check the operating safety of the vehicle.