ASV SC50 Scout Track Loader Hot Fluids and Components Stay clear of hot components and system fluids of the engine, exhaust, radiator/oil cooler and hydraulic lines/tubes. Also, use caution when removing fill caps, breathers and plugs on the machine. Hold a rag over the cap or plug to prevent being sprayed or splashed by liquids under pressure. Be especially careful if the machine has been operated recently, fluids may still be hot. To ensure your safety, allow the machine to cool before attempting any service procedure that involves hot fluids or components. ASV SC50 Scout Track Loader Service Manual,ASV SC50 Scout Track Loader Repair Manual,ASV SC50 Scout Track Loader User Manual,ASV SC50 Scout Track Loader Owner's Manual,ASV SC50 Scout Track Loader Maintenance Manual
ASV SC50 Scout Track Loader Repairs requiring welding should be performed only by personnel adequately trained and knowledgeable in welding procedures and with the guidance of appropriate reference information. Determine the type of metal being welded and select the correct welding procedure and filler material to provide a weld that is as strong or stronger than the original weld.
Always tighten connections to the correct torque specification. Make sure that all shields, clamps and guards are installed correctly to avoid excessive heat, vibration or unwanted contact between parts during operation. Shields that protect exhaust components from oil spray in event of a line, tube or seal failure must be correctly installed.
ASV SC50 Scout Track Loader Work Tools (Attachments)
Only use work tools that are recommended by ASV. Make sure that all necessary guards and protective equipment are in place and functioning prior to operating any work tool.
ASV SC50 Scout Track Loader Asbestos Information
Equipment and replacement parts shipped from the manufacturer are asbestos free. When replacement parts are required, use only genuine manufacturer’s replacement parts. Use caution when handling replacement parts from another supplier if these parts contain asbestos. Avoid inhaling dust that might be generated when handling these components or when handling asbestos debris. Inhaling this dust can be hazardous to your health. The components that may contain asbestos fibers are lining material, and some gaskets. The asbestos that is used in these components is usually encased in a resin or sealed in some way. Normal handling is not hazardous unless airborne dust containing asbestos is generated.
ASV SC50 Scout Track Loader Service Tools
Listed below are common service tools which are identified and utilized in the service procedures described in this manual. Use tools recommended by ASV whenever possible to reduce risk of injury and or machine damage during service.
- ASV Jack Stands (2) (ASV P/N: 0402-900) (you will need crossmembers (2) P/N: 0403-472)
- Heavy Duty Hydraulic Jack (5-ton rating)
- Test Gauge Kit (ASV P/N: 0402-935)
- Ratchet Strap
- Long Pry Bar(s)
- ASV Service Cart (0402-871)
ASV SC50 Scout Track Loader Auxiliary Pump
- Make: Haladex Barnes Hydraulics
- Type: Gear pump
- Displacement: 1.343 in3/rev (22 cc/rev)
- Max Flow: 16.3 gpm (61.7 lpm) @ 2800 rpm
- Relief pressure: 3000 psi (20,680 kPa)
- Cooling/filtering: Oil is filtered and cooled at all times. In auxiliary mode, the oil is filtered after the attachment to protect the machine if the attachment motor fails or contaminants are introduced from the quick couplers.
Chapter Overview
This chapter contains diagrams for the following SC-50 circuits and sub components: hydraulic charge circuit, hydraulic auxiliary circuit, hydraulic drive circuit, steering control valve, auxiliary control block, brake/2-speed control block, pilot generation (solenoid) block, shuttle block, and directional control valve.