Dodge Ram Truck Service Repair Manual Suspension

INTERMITTENT WIRING AND CONNECTORS
The conditions necessary to set this DTC are not present at this time. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit. Wiggle test the wiring harness and connectors while checking for shorted and open circuits. Using the DRBIIIT, monitor the data related to this circuit while performing the wiggle test. Look for the data to change or for the DTC to reset. While monitoring the Stabilizer Bar State on the DRBIIIT, move the switch to each position. The DRBIIIT display must match the position on the actual switch.

Dodge Ram Truck Manual Suspension C2124-STABILIZER BAR INDICATOR CONTROL CIRCUIT (CONTINUED)
For a complete wiring diagram Refer to Section 8W.

• When Monitored: Ignition on.
• Set Condition: The FDCM has detected a short to voltage, ground or an open in the Stabilizer Bar Disengage or Engage Illumination Sense circuits.

DISCONNECTING STABILIZER SWITCH

1. (T539) STABILIZER BAR DISENGAGE ILLUMINATION SENSE SHORT TO VOLTAGE
2. (T539) STABILIZER BAR DISENGAGE ILLUMINATION SENSE SHORT TO GROUND
3. (T539) STABILIZER BAR DISENGAGE ILLUMINATION SENSE OPEN
4. (T529) STABILIZER BAR ENGAGE ILLUMINATION SENSE SHRORT VOLTAGE
5. (T529) STABILIZER BAR ENGAGE ILLUMINATION SENSE SHRORT GROUND
6. (T529) STABILIZER BAR ENGAGE ILLUMINATION SENSE OPEN FDCM

(T530) STABILIZER BAR DISENGAGE ILLUMINATION SENSE CIRCUIT OPEN
Measure the resistance of the (T530) Stabilizer Bar Disengage Illumination Sense circuit between the Disconnecting Stabilizer Bar Switch harness connector and the FDCM harness connector.